Guide updated 6 November 2026
Moon Sweepers Packager Guide
Set up a short delivery route, follow the first capsule and check the depot before extending your belt.
Moon Sweepers Packager: setup and first delivery
Quick answer: use a Packager to load collected dust near your work area and send capsules toward the depot by conveyor. It shortens repeated carrying trips; a working output route is part of the purchase.
Several guides report a $50 Building Tool and a $100 Packager under Logistics; check both prices and availability in your build. The Packager handles dust you bring to it: it is not a brush or a processing machine. Once the route works, compare the robot and processing layouts before adding equipment.
- Equip the Building Tool and find the Packager in Logistics. Place it close to the area you are sweeping, with room for a belt at its output.
- Connect the output to a conveyor leading to the station's receiving intake. Check each segment's direction and connection.
- Collect a small load, approach the Packager and use its interaction prompt. Guides report E by default; use your displayed binding.
- Watch the first capsule leave, travel along the belt and reach the intake. Compare the depot display and balance before extending the line.

Packager, Auto Packer or manual delivery?
Check the first capsule
- Before loading: note the balance, make sure your tool contains dust, and leave space for the outgoing belt. Reference guides identify the output at the rear; verify the port and direction in your build.
- At the Packager: use the shown loading prompt and watch the tool gauge decrease. Guides report that capsules may leave over time, so allow the first one to appear.
- At each hand-off: watch the capsule move along every section. At a junction, check that the destination branch is connected and not blocked.
- At the depot: watch the capsule enter the intake and compare the screen and balance. Patch 1.0.3 says dust and stone arriving by belt are paid as they arrive.
Plan for the Building Tool, Packager and the full belt, not just the machine price. Check the cost and build menu in your save; different guides give incomplete or inconsistent information about power and other requirements.

Locate the first failed step
Use this diagnostic sequence on one short route. Change one connection at a time and repeat the same small-load test, so you can tell which change helped.
| What you observe | Next check | What confirms progress |
|---|---|---|
| The tool still holds its dust | Read the loading prompt and confirm you are interacting with the Packager. | The tool gauge decreases or the machine's loaded amount changes. |
| Material is loaded but nothing leaves | Inspect the output connection and any machine message before changing the whole belt. | A capsule appears on the connected output. |
| A capsule stops partway | Inspect the first stopped join, direction or downstream machine. | The next test capsule passes that exact point. |
| The last belt moves but no sale registers | Follow the capsule into the receiving intake and compare the depot display with your balance. | The intake accepts the capsule and the delivery registers. |
Keep a useful test record
Note the game version, solo or co-op session, starting balance, loaded amount and the first place movement stops. Capture the machine message and both ends of the connection. Avoid simultaneous purchases or other deliveries while comparing balances; they can hide the result of your test.
These setup steps combine reference-guide reports with the developer's patch notes. They have not been independently play-tested; check your build and on-screen prompts. For a stopped line, see the conveyor troubleshooting checklist.